Operational Check
The operational check tests the communication link between the remote control and the
DCP501. The procedures verify the DCP501 response to remote control commands.
Table 3-1 lists the operational check procedures:
Table 3-1
Operational check
Feature
Power on
Channel Selection
Volume Control
If the DCP501 does not operate properly, refer to Section 5, " Troubleshooting."
Testing Procedure
!
Press
to turn on the DCP501.
POWER
!
Turn on the TV and select a video source.
!
Scan through the channels using the
the
+ - buttons on the remote control.
CHANNEL
!
Tune to several channels by entering the channel number with the numeric
buttons on the remote control.
!
Turn the TV volume down completely. Use the DCP501 volume control to adjust
the sound volume to a moderate level.
!
Press
+ - on the remote control to increase to a comfortable level.
VOLUME
!
Press
to turn the sound completely off. Press
MUTE
sound.
Installation
56 buttons on the DCP501 and
CHANNEL
again to restore the
MUTE
DCP501 Installation Manual
3-25