Table of Contents
Advertisement
Fi ndi ng a Setup Code
Setup codes for your TV and VCR are listed by brand in Appendix B, "TV and VCR Setup
Codes".
If the setup code for your brand of TV or VCR is not listed, or if your TV or VCR does not
respond to the setup codes listed for its brand, you can search for your setup code using your
remote control's Step and Set function.
To search for a setup code:
Press the mode button for the device (either TV, VCR 1 or VCR 2) for six seconds.
1
The mode buttons will turn on and turn off one at a time. This sequence will repeat two
times and then the selected mode button will remain on. This indicates the remote is ready
to use the Step and Set function.
Press the Cursor Up
2
If no setup code is currently programmed for the selected mode, the search begins with the
most popular setup code for the selected device. If a setup code has been previously
programmed, the search begins with the next setup code for that device.
Use the following buttons to determine if the setup code properly operates the selected
3
device:
Number buttons 0, 1, 2, or 3 (use to test TV setup codes)
Channel Up (use to test TV setup codes)
Play (use to test VCR setup codes)
Rewind (use to test VCR setup codes)
If the setup code successfully operates the device, press OK on the remote control. The setup
4
code is now programmed into your remote control.
If the setup code does not operate the device, repeat steps 2 and 3.
During Step and Set, if there is more than a ten second pause between pressing buttons on the
remote control, the remote will exit Step and Set and return to the previously programmed
setup code.
You can only set up your remote control while in TV, VCR 1 or VCR 2 mode.
Installing Batteries in Remote Control
Before using the remote control, you must install two AA (1.5 V) alkaline batteries (included), as
illustrated in Figure 7.
To install batteries in the remote control:
Press and slide the battery compartment cover off.
1
Place the batteries in the compartment; be careful to observe the correct polarity.
2
Slide the battery compartment cover back into place.
3
∧ ∧ ∧ ∧
button to begin Step and Set. The selected mode button will turn off.
O v e r v i e w
2 1
DCP 501 U ser Gu i d e
Advertisement
Table of Contents
