Nortel CallPilot 150 Installation And Maintenance Manual page 76

76 Modem Access
7 Click the Dial button.
The Operator-Assisted or Manual Dial dialog box appears.
8 Use the telephone connected to your computer modem to dial the CallPilot system you want to
access. You must be answered by the CallPilot voicemail.
9 When voicemail answers, log into the administrators mailbox using the Modem Access
password. To do this, press •• , the System Administrator mailbox number, the Modem
Access password and then £ .
For example, ••⁄Øؤ⁄⁄⁄⁄£.
Note: If you are in Europe or Australia, press °° , the System Administrator
mailbox number the Modem Access password and then £ .
For example, °°⁄Øؤ⁄⁄⁄⁄£ .
10 If there are enough CallPilot resources to make a modem connection, the system starts
counting down from 5.
11 When the system reaches 1, click the Connect button and hang up the telephone.
A message appears when the connection is established.
Tip
If the prompt One moment please plays, the system currently does not have sufficient
resources to access the modem. Wait until the count down reaches 1 before you click the
Connect button.
If the prompt One moment please plays several times and then the prompt Exiting the
system, goodbye plays, try calling again.
Your computer is now connected to the CallPilot system and you can access the web interface.
Accessing the CallPilot system using the CallPilot console
1 Click the Start button and then click Run.
2
Enter Telnet 192.168.0.2 and click OK.
Note: The IP address above is an example only. The IP address you enter is the IP
address of the CallPilot system plus one.
In the example above, the IP address shown is the default CallPilot IP address
(192.168.0.1) plus one (192.168.0.2).
3 Log on to the CallPilot console.
When you are finished with the CallPilot system, end your connection to the CallPilot modem.
Note: After you are finished accessing the CallPilot system, you must reconfigure your
modem if you want to use it for normal modem connections.
P0604218 02