Nortel CallPilot 150 Installation And Maintenance Manual page 59

5 Insert the new feature cartridge into the bottom PCMCIA slot.
For the location of the PCMCIA slots, refer to
6
Connect power to the CallPilot 150.
The CallPilot 100/150 will reboot.
Note: A correct reboot of the CallPilot 150 is indicated by the following LED
sequence:
•
•
•
•
•
•
If the CallPilot 150 does not reboot, make sure the feature cartridge is in the bottom
PCMCIA slot and is properly seated. If the feature cartridge is not inserted properly,
disconnect the power from the CallPilot 150, insert the feature cartridge in the bottom
slot and restore power.
7 Use CallPilot Manager to change the Country setting to the country that was selected before
the upgrade. For information about how to change the Country settings, refer to the CallPilot
Manager Set Up and Operation Guide.
8 Use the Language Configuration Utility to change the Languages settings to the languages that
were selected before the upgrade. For information about how to use the Language
Configuration Utility, refer to
9
Restore your CallPilot information. For information about how to restore the CallPilot
information, refer to
LEDs 1 to 4 light for approximately 20 seconds
LEDs 1 to 4 turn off for approximately 25 seconds
LEDs 1 to 4 blink rapidly for approximately 30 seconds
LEDs 1 to 4 turn off for approximately 50 seconds
some or all of the LEDs 1 to 4 may light to indicate TCM connections
to the CallPilot on these ports
LED lights to indicate that CallPilot is operating normally
"Language Configuration Utility" on page
"Restoring the CallPilot information" on page
CallPilot 100/150 Installation and Maintenance Guide
Chapter 9 Upgrading CallPilot 100/150
Figure 1 on page 19.
53.
59
43.