Upgrading The Message Storage - Nortel CallPilot 150 Installation And Maintenance Manual

58 Chapter 9 Upgrading CallPilot 100/150
6 The CallPilot 100/150 copies the files from the upgrade cartridge to the feature cartridge.
During the upgrade, the LEDs turn on and off in the following sequence:
• LEDs 1 to 4 cycle on and off, one at a time, for approximately 8 to 10 minutes
• LEDs 1 to 4 turn off for approximately 40 seconds
• some or all of the
on these ports
7
Wait until the
8
Unplug the power connector from the CallPilot 100/150.
9 Press the eject button on the top PCMCIA slot to remove the upgrade cartridge.
Note: When removing the upgrade cartridge, be careful not to dislodge the feature
cartridge in the bottom slot. If the feature cartridge becomes dislodged, ensure it is
fully inserted before you restore power.
10 Restore power to the CallPilot 100/150.
The CallPilot 100/150 will reboot. At this point it begins any necessary conversions.
11 If necessary, you can restore your CallPilot information. For information about how to restore
the CallPilot information, refer to

Upgrading the message storage

Message storage is the amount of memory available on your CallPilot system to store greetings
and voice mail messages. You can upgrade the message storage on your CallPilot 150 from 24
hours to 59 hours.
Note: You cannot upgrade the message storage time on a CallPilot 100.
To upgrade the message storage, you replace the existing feature cartridge with the expanded
memory feature cartridge. Contact your Nortel Networks sales representative for information on
how to obtain an expanded memory feature cartridge.
To upgrade the message storage:
1 Backup your CallPilot information. For information about how to backup CallPilot, refer to
"Backing up the CallPilot information" on page
2 Put on an anti-static strap and connect it to a grounded metal object.
3 Unplug the power connector from the CallPilot 150.
4
Press the eject button on the bottom PCMCIA slot to remove the feature cartridge.
P0604218 02
LEDs 1 to 4 may light to indicate TCM connections to the CallPilot
LED turns on.
"Restoring the CallPilot information" on page
51.
53.