Nortel CallPilot 150 Installation And Maintenance Manual page 33

7 Press the Enter key.
Note: If you do not press a key within 2 seconds of this prompt appearing, repeat
steps 5 and 6.
The prompt
(M)odify any of this or (C)ontinue?
8 Press the M key and press the Enter key.
The prompt
Do you want a LAN interface?
9
Press the Y key and press the Enter key.
The prompt
This board's LAN IP Address (0.0.0.0 = RARP)
10 Type the IP address for the CallPilot 100/150 in a valid dotted format and press the Enter key.
The prompt
Subnet mask for LAN (0 for none)
11 Type the Subnet Mask for the CallPilot 100/150 in a valid dotted format and press the Enter
key.
The prompt
Should there be a default gateway for packet routing?
12 If the CallPilot 100/150 needs a next hop router, press the Y key and press the Enter key.
If the CallPilot 100/150 does not need a next hop router, press the N key, press the Enter key
and go to step 15.
The prompt
IP address of default gateway?
13 Type the IP address of the next hop router in a valid dotted format and press the Enter key.
14 Press the Enter key until the following prompt appears.
(M)odify any of this or (C)ontinue?
15 Press the C key and press the Enter key.
16 Connect the LAN cable to the Ethernet port on the CallPilot 100/150.
You can now initialize the CallPilot parameters. For information about how to initialize the
CallPilot , refer to "Running the Quick Install Wizard" on page
Chapter 5 Initializing the CallPilot 100/150
appears.
appears.
appears.
appears.
35.
CallPilot 100/150 Installation and Maintenance Guide
33
appears.
appears.