34
Chapter 5 Initializing the CallPilot 100/150
Changing the IP address using an Ethernet crossover cable
Using an Ethernet crossover cable, you can connect the CallPilot 100/150 to your computer. With
this connection, you can use CallPilot Manager to change the CallPilot 100/150 IP address before
you connect it to the network.
Note: If you do not have access to the CallPilot 100/150 through the network, you can use
an Ethernet crossover cable to configure all of the CallPilot 100/150 parameters.
To use an Ethernet crossover cable, your computer must be equipped with a 10/100 BaseT
Ethernet card and support TCP/IP protocol.
Figure 4 Ethernet crossover cable
Note: An Ethernet crossover cable is available as a separately available part. For
information about obtaining an Ethernet crossover cable, contact your Nortel Networks
supplier.
Connecting the Ethernet crossover cable
1
Shut down the computer.
2
Attach one end of the Ethernet crossover cable to the Ethernet port on the CallPilot 100/150.
3
Connect the other end of the cable to the network interface card on your computer.
4
Start the computer.
5
Use the Quick Install Wizard to initialize the CallPilot 100/150.
For information about how to use the Quick Install Wizard, refer to
Wizard" on page
P0604218 02
Figure 4
35.
shows the connections required.
"Running the Quick Install