Restoring The Callpilot Information - Nortel CallPilot 150 Installation And Maintenance Manual

9 Start the CallPilot Backup and Restore Utility (CallPilotBRU.exe).
The CallPilot Backup/Restore Utility screen appears.
10 Click the Backup option.
11 In the Local Folder box, enter the path name of the directory on your computer in which you
want to store the CallPilot information.
12 In the CallPilot 150 hostname or IP addresses box, enter the host name or IP address of the
CallPilot 100/150
13 Click the OK button.
A confirmation dialog box appears.
14 If the information on the confirmation dialog is correct, click the Continue button.
If the information is not correct, click the Cancel button and repeat steps 10 to 12.
A dialog box appears when the backup is completed.
15 Click the Continue button.
16 Reboot the CallPilot 100/150

Restoring the CallPilot information

If your CallPilot 100/150 has been replaced or has lost its programming information, you can
restore the CallPilot programming, greetings and voice messages from a previous back up.
Note: You must have a back up of the CallPilot information stored on your computer to
perform a restore.
You must install the CallPilot Backup and Restore Utility on the computer you are using to
restore the CallPilot information.
Caution: Do not use CallPilot Manager to perform any administrative tasks while a
restore is in progress. If you use CallPilot Manager to make a change during a restore, the
CallPilot 100/150 can become corrupted and inoperable.
To help prevent other people from making changes during a restore, inform anyone with
administrative privileges that you are doing a restore and that they should not access
CallPilot Manager until the restore is completed.
CallPilot 100 you want to backup.
/
CallPilot 100
/
Chapter 8 Backing up and restoring CallPilot
CallPilot 100/150 Installation and Maintenance Guide
53