Lotus Elise Service Notes page 510

Lotus Service Notes
Section XA
to one of the ends, use splice crimp, solder and heatshrink, to connect the new green 1.0 mm wire
leading to the new fuse holder to be attached to the side of the main fusebox and equipped with a 10A
fuse.
- Insert into the other cavity of the new fuseholder, the terminated green wire from the new switchbox.
- To the remaining end of the cut white cable, splice crimp, solder and heatshrink the unterminated green
wire from the new switchbox.
With revised harness:
- Release the main fusebox fixings, remove fuse 7, and extract the green cable from cavity 7B. Cut off
the terminal from this cable and use splice crimp, solder and heatshrink to connect with the unterminated
green cable from the new switchbox.
- Insert the terminated green wire from the new switchbox into the vacated fusebox cavity 7B.
- Replace fuse 7 (10A) and refit the fusebox.
Operating switch
Bowden
cable
Switchbox
Prior to revised
harness
Green: to new fuseholder
Unterminated black: to
alternator dump resistor
Black: to battery negative
Black: to cavity 'B' in 2-way
master switch connector
Unterminated green: spliced
to main harness white
With revised
harness
[HI
Green: to new fuseholder
Unterminated black: to alternater dump
resistor
Black: to battery negative
Unterminated green: spliced to green
cable extracted from fusebox cavity 7B
Black: to cavity 'B' in 2-way master
switch relay connector
/m Page 28