Lotus Elise Service Notes page 364

D Lotus Service Notes
Section JH
Power Harness;
Adaptor Harness;
MEMS 1.9 Programme Card;
5AS Security Programme Card;
Security Module ('Dongle');
Instruction Booklet.
Power harness
To Connect 'Lotus Check'
To connect the equipment, proceed as follows:
i). Open the front and rear compartment lids;
ii). Connect the power harness crockodile clips to the battery in the front compartment;
iii). Plug the adaptor harness into the 16 terminal diagnostic link connector (DLC) next to the MEMS 1.9 ECU
at the left hand side of the rear compartment, and also connect to the power harness;
iv). Select '5AS' on the adaptor harness switch;
v). Plug the power harness into the scanner tool and the printer;
vi). Insert the Security System programme card into the scanner tool slot, label uppermost.
vii). Plug the security dongle into the scanner tool.
viii). Press F2.
Password Security System
In order to control and monitor the security operations performed in the field using the Lotus Check, a
password system is used in conjunction with nominated supervisors at each dealership. On receipt of the
Lotus Check kit, the accompanying 'Supervisor Password
1
form should be completed and telefaxed to Omitech
Instrumentation. Note that the serial number etched on the back of the security programme card must be
quoted. Omitech will then telephone the supervisor with a password, comprising a sequence of eight button
presses on the six button scanner tool. The password should be noted and kept secure by ihe supervisor for
only his/her use.
This password allows 50 security operations to be performed, where such an operation is defined as
either ECM matching, or transmitter key matching. The supervisor allocates between 1 and 20 operations, or
charges, to a 'user' password of his/her choice, which is used by a technician when performing the actual task.
Page 364 1998 / 03