Lotus Elise Service Notes page 508

Lotus Service Notes
Section XA
XA.12 - BATTERY ISOLATOR SWITCH KITS
This dual pole flick switch is mounted in the cabin and operates the ignition circuit directly, and via a relay
in the battery compartment, all other battery sen/ices. An alternator dump resistor is incorporated to protect
the alternator from damage. In addition, external operation of the switch is provided for by a Bowden cable link
from a pull handle located in the topshell near the windscreen base.
Contents of Kit
Battery Isolator Switch Kit (prior intro. of revised harness)* A111M0128S 1
Battery Isolator Switch Kit (from intro. of revised harness)* A111M0129S 1
comprising:
Switch Box Assembly (prior revised harness) A111M0126S 1
Switch Box Assembly (revised harness) A111M0125S 1
Master Switching Relay A111M6087S 1
Bowden Cable A111M6088S 1
Battery Positive Link Cable A111M0109S 1
Miscellaneous Parts
New harness introduced at VIN: W 1941. Plus; 1920, 1926, 1937, 1938. Less; 1965, 2002.
Component Siting
1. Switch Box Assembly: Position the switch box on the car centreline (or offset if plumbed-in fire extin-
guisher system is fitted) beneath the dash, mark up the two pre-drilled holes in the box against the dash,
and drill the dash to secure the box using two self tapping screws A075W5014Z. Route the harness
alongside the main harness and through the bulkhead grommet to the front of the battery well.
/m Page 26