Lotus Elise Service Notes page 446

Lotus Service Notes
Section XA
To remove the matrix or blower fan unit, the complete assembly should be removed from the chassis:
1. Remove the washer bottle, battery and blower fan outlet ducting.
2. Label and disconnect the electrical leads to the blower fan.
3. Release the spring clip securing the outer control cable to the matrix moulding, and unhook the inner
cable from the flap lever.
4. Release the two hoses from the matrix inlet and outlet connections, and immediately plug to reduce
coolant loss.
5. Remove the four screws securing the matrix/blower fan assembly to the chassis, and withdraw the com-
plete unit.
6. Unhook the rubber strap to separate the matrix and mouldings from the blower fan unit.
7. Re-assemble in reverse order to the above, noting that on LHD cars, a spacer is used between the fan
housing and the rear of the chassis well. Note that the control cable to the air blender flap is connected
to the outermost hole in the flap lever arm.
Page 15