Lotus Elise Service Notes page 25

Lotus Service Notes
Section TDM
Hook the longeron over the edge of the subframe and onto the adhesive and slide fully forward until
aligned with the rivet holes and roll over bar brace fixing hole in the tapping block. If an aluminium boot
floor is used (i.e. pre 'boot box'), fit the floor into position between the longerons before inserting the three
6.4 mm (1/4") rivets each side to secure the longeron (and boot floor if applicable) to the subframe. Fit
the M10 caphead screw and washer to secure the roll over bar stay and longeron to the damper mounting
tapping block.
6. Fit the exhaust heatshield, electrical component plate and other components in reverse order to removal.
Tapping block
Page 17