Lotus Elise Service Notes page 488

Lotus Service Notes Section XA
Old type; 1.6 mm thick, 10 mm wide.
Later type; 2.0 mm thick, 15 mm wide. (C111J0046F)
If necessary, rivet the later type bracket to the pedal using a 3/16" dia. 1/2" reach pop rivet.
12. Also at the pedal box, check the specification of the throttle linkage relay lever. The later type (B111J0045F
introduced February '98) must be fitted which is notched to allow for clearance with the mounting plate
fixing with the greater required lever travel. Alternatively, the existing lever may be modified as shown
below:
Adjust the cable at the throttle body abutment to allow full throttle to be attained. If necessary, adjust the
pedal upstop and pedal pullrod length. Ensure that the pedal downstop is set to protect the cable from
strain at full throttle.
13. The engine is supplied with a new ECM together with a matched security 5AS module. If the car is to be
used in competition, it is recommended to disable the passive immobilisation by disconnecting the driver's
door switch. The alarm may still be armed on demand, but will not be triggered by the driver's door.
If the car is equipped with the optional Cobra alarm system, passive immobilisation can be overridden by
unplugging the immobiliser module and substituting bridging plug A111M0123S.
Cobra immobiliser module
Engine
management
ECM
Anti-tamper cover
Im225l
Page 15