Lotus Service Notes
Section TDM
5404 (see sub-section BM.5).
- Apply a bead of Betaseal/mate adhesive (see sub-section BM.5) to the windscreen frame flange, and fit
the frame panel into position.
15. Locate the top of the windscreen frame by fitting the cant rails into position, and secure the frame such
that the cant rails are held against their striker plates on the roll over bar, but with out the foam seals on
their front end being compressed. After further assembly, the thickness of the header rail moulded carrier
strip and tongue strip (see sub-section BN.14) provide the appropriate seal compression to locate the
cant rails.
Windscreen frame bonding (sills not shown)
Windscreen frame.
Ib281I
Bonding path
Page 17