Checking The Rear Hub Rubber Dampers - KTM 690 Enduro R USA 2013 Owner's Manual

13 WHEELS, TIRES
13.5

Checking the rear hub rubber dampers

Info
The engine power is transmitted from the rear sprocket to the rear wheel via 6 rubber dampers. They eventually wear out during
operation. If the rubber dampers are not changed in time, the rear sprocket carrier and the rear hub will be damaged.
–
Push the rear wheel forward as far as possible and lay the chain on the rear sprocket.
–
Install the wheel spindle, the chain adjusters and the nut.
Guideline
In order that the rear wheel is correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks
Info
Mount the left and right chain adjusters
100270-10
–
Tighten nut
Guideline
Nut, rear wheel spindle
–
Operate the foot brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
Finishing work
–
Remove the motorcycle from the lift stand. (
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the rear wheel.
.
3
x ( p. 120)
in the same position.
4
M25x1.5 90 Nm
(66.4 lbf ft)
p. 78)
p. 78)
122
.
A