Cleaning, Care; Cleaning The Motorcycle - KTM 690 Enduro R USA 2013 Owner's Manual

18

CLEANING, CARE

18.1

Cleaning the motorcycle

Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
–
When cleaning the vehicle with a pressure cleaner, do not point the water jet directly onto electrical components, connectors, cables,
bearings, etc. Maintain a minimum distance of 60 cm between the nozzle of the pressure cleaner and the component. Excessive pres-
sure can cause malfunctions or destroy these parts.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
If you clean the motorcycle regularly, its value and appearance will be maintained over a long period.
Avoid direct sunshine on the motorcycle during cleaning.
–
Seal the exhaust system to keep water out.
–
First remove coarse dirt particles with a gentle spray of water.
–
Spray very dirty areas with a normal motorcycle cleaner and then clean with a brush.
Motorcycle cleaner (
Info
Clean the vehicle using a soft sponge and warm water containing normal motor-
cycle cleaner.
Never apply motorcycle cleaner to the dry vehicle; always rinse with water first.
401061-01
If the vehicle was operated in road salt, clean it with cold water. Warm water
enhances the corrosive effects of salt.
p. 198)
166