KTM 690 Enduro R USA 2013 Owner's Manual page 174

20 TROUBLESHOOTING
Faults
Engine overheats.
FI warning lamp (MIL) lights/flashes
Engine dies during the journey
High oil consumption
Headlight and parking light are not
functioning
Turn signal, brake light and horn not
functioning
Time is not (correctly) displayed
Possible cause
Foam formation in cooling system
Buckled or damaged radiator hose
Thermostat is faulty
Fuse 5 blown
Defect in radiator fan system
Air in cooling system
Defect in fuel injection system
Lack of fuel
Fuse 1, 2 or 4 blown
Engine vent hose bent
Engine oil level too high
Engine oil too thin (low viscosity)
Fuse 7 blown
Fuse 6 blown
Fuse 2 blown
Action
–
Drain the coolant. x (
–
Fill/bleed the cooling system.
–
Change the radiator hose.
–
Check the thermostat.
x
–
Change the fuses of individual power consumers.
( p. 134)
–
Check the radiator fan system.
–
Fill/bleed the cooling system.
–
Read out the fault memory using the KTM diag-
nostics tool. x
–
Refuel. ( p. 60)
–
Change the fuses of individual power consumers.
( p. 134)
–
Route the vent hose without bends or change it if
necessary.
–
Check the engine oil level. (
–
Change the engine oil and filter, clean the oil
screens. ( p. 158)
x
–
Change the fuses of individual power consumers.
( p. 134)
–
Change the fuses of individual power consumers.
( p. 134)
–
Change the fuses of individual power consumers.
( p. 134)
–
Set the clock. ( p. 38)
172
p. 149)
x ( p. 150)
x
x
x ( p. 150)
p. 157)