Installing The Rear Wheel - KTM 690 Enduro R USA 2013 Owner's Manual

13 WHEELS, TIRES
13.4

Installing the rear wheel

Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents No braking effect when operating the rear brake.
–
After installing the rear wheel, always operate the foot brake until the pressure point is reached.
x
Main work
–
Check the rear hub rubber dampers.
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Replace the wheel bearing.
–
Remove bushing
ring .
2
Long-life grease (
–
Clean and grease the thread of the wheel spindle and nut
Long-life grease (
100269-10
–
Install the rubber damper and rear sprocket carrier in the rear wheel.
–
Position the rear wheel.
The brake linings are correctly positioned.
x ( p. 122)
x
. Clean and grease the contact surfaces of the bushings of shaft seal
1
p. 198)
p. 198)
121
.
3