Checking The Starter Clutch; Installing The Starter Clutch - Yamaha FZ6-SS Service Manual

STARTER CLUTCH AND GENERATOR
5-36
EAS00351

CHECKING THE STARTER CLUTCH

1. Check:
S starter clutch rollers 1
Damage/wear ! Replace.
2. Check:
S starter clutch idle gear 1
S starter clutch drive gear 2
Burrs/chips/roughness/wear ! Replace
the defective part(s).
3. Check:
S starter clutch gear's contacting surfaces a
Damage/pitting/wear ! Replace the starter
clutch gear.
4. Check:
S starter clutch operation
a. Install the starter clutch drive gear 1 onto
the starter clutch 2 and hold the starter
clutch.
b. When turning the starter clutch drive gear
clockwise A , the starter clutch and the start-
er clutch drive gear should engage, other-
wise the starter clutch is faulty and must be
replaced.
c. When turning the starter clutch drive gear
counterclockwise B , it should turn freely,
otherwise the starter clutch is faulty and must
be replaced.
EAS00355

INSTALLING THE STARTER CLUTCH

1. Install:
S starter clutch
NOTE:
S While holding the generator rotor 1 with the
sheave holder 2 , tighten the starter clutch
bolt.
ENG
32 Nm (3.2 mSkg, 23 ftSlb)
R
LOCTITE