Lock Washers/Plates And Cotter Pins; Bearings And Oil Seals; Circlips - Yamaha FZ6-SS Service Manual

IMPORTANT INFORMATION
EAS00023
LOCK WASHERS/PLATES AND COTTER
PINS
After removal, replace all lock washers/plates
1 and cotter pins. After the bolt or nut has been
tightened to specification, bend the lock tabs
along a flat of the bolt or nut.
EAS00024

BEARINGS AND OIL SEALS

Install bearings and oil seals so that the
manufacturer's marks or numbers are visible.
When installing oil seals, lubricate the oil seal
lips with a light coat of lithium-soap-based
grease. Oil bearings liberally when installing, if
appropriate.
1 Oil seal
CAUTION:
Do not spin the bearing with compressed air
because this will damage the bearing sur-
faces.
1 Bearing
EAS00025

CIRCLIPS

Before reassembly, check all circlips carefully
and replace damaged or distorted circlips. Al-
ways replace piston pin clips after one use.
When installing a circlip 1 , make sure the
sharp-edged corner 2 is positioned opposite
the thrust 3 that the circlip receives.
4 Shaft
1-7
GEN
INFO