Yamaha FZ6-SS Service Manual page 410

Left turn signal/position light
Positive tester probe ! ground
Negative tester probe ! chocolate
Right turn signal/position light
Positive tester probe ! ground
Negative tester probe ! dark green
A B
C
S Turn the main switch to "ON".
S Set the turn signal switch to "
S Measure the voltage (DC 12 V) of the choco-
late or dark green
1 2
connector (wire harness side).
S Is the voltage within specification?
YES
This circuit is OK.
EAS00801
4. The neutral indicator light fails to come on.
1. Neutral indicator light (LEDs)
S Check the neutral indicator light for continu-
ity.
Refer to "CHECKING THE LEDs".
S Are the neutral indicator light OK?
1
2
" or " ".
at the turn signal light
NO
The wiring circuit
from the turn signal
switch to the turn sig-
nal light connector is
faulty and must be
repaired.
8-39
SIGNALING SYSTEM
YES
2. Neutral switch
S Check the neutral switch for continuity.
Refer to "CHECKING THE SWITCHES".
S Is the neutral switch OK?
YES
EAS00753
3. Starting circuit cut-off relay (diode)
S Disconnect the starting circuit cut-off relay
coupler from the wire harness.
S Connect the pocket tester (Ω
starting circuit cut-off relay coupler as
shown.
S Check the starting circuit cut-off relay for
continuity.
Positive tester probe !
black/red
Negative tester probe !
Positive tester probe !
Negative tester probe !
black/red
NOTE:
When you switch the positive and negative
tester probes, the readings in the above
chart will be reversed.
ELEC
NO
Replace the meter
assembly.
NO
Replace the neutral
switch.
1) to the
1
Continuity
2
sky blue
sky blue
2
No
continuity
1