Yamaha FZ6-SS Service Manual page 27

Tool No.
Middle driven shaft
Middle driven shaft bearing driver
bearing driver
Mechanical seal installer
90890-04058
YM-4058
Mechanical seal
These tools are used to install the water pump
installer
90890-04078
seal.
YM-33221
Clutch holding tool
90890-04086
This tool is used to hold the clutch boss
YM-91042
when removing or installing the clutch boss
nut.
Valve lapper
90890-04101
This tool is needed to remove and install
the valve lifter.
Valve guide remover (φ4)
90890-04111
This tool is used to remove or install the valve
guides.
Valve guide installer (φ4)
90890-04112
This tool is used to install the valve guides.
Valve guide reamer (φ4)
90890-04113
YM-04113
This tool is used to rebore the new valve
guides.
Ignition checker
90890-06754
YM-34487
This tool is used to check the ignition system
components.
Vacuum/pressure pump gauge set
90890-06756
YB-35956
This tool used to measure the vacuum pres-
sure.
Yamaha bond No. 1215
90890-85505
ACC-11001-
05-01 This bond is used to seal two mating surfaces
(e.g., crankcase mating surfaces).
SPECIAL TOOLS
Tool name/Function
1-11
GEN
INFO
Illustration