Yamaha FZ6-SS Service Manual page 305

CONNECTING RODS AND PISTONS
9. Tighten:
Tighten the connecting rod bolts using the
plastic-region tightening angle method.
a. Clean the connecting rod bolts.
b. Tighten the connecting rod bolts.
c. Put a mark 1 on the corner of the connecting
d. Tighten the bolt further to reach the specified
e. After the installation, check that the section
S When the bolt is tightened more than the
S If they are not flush with each other, remove
S Do not use a torque wrench to tighten the
S Tighten the bolt until it is at the specified
5-86
S connecting rod bolts
15 Nm (1.5 mSkg, 11 ftSlb) + 120_
CAUTION:
rod bolt 2 and the connecting rod cap 3 .
angle (120_).
shown a is flush with each other by touching
the surface.
S Side machined face a
WARNING
specified angle, do not loosen the bolt and
then retighten it.
Replace the bolt with a new one and per-
form the procedure again.
the connecting rod bolt and big end bear-
ing and restart from step "7". In this case,
make sure to replace the connecting rod
bolt.
CAUTION:
bolt to the specified angle.
angles.
ENG