Checking The Front Fork - Yamaha FZ6-SS Service Manual

CHECKING AND ADJUSTING THE STEERING HEAD/

CHECKING THE FRONT FORK

e. Repeat the above procedure on the opposite
handlebar.
f. If the steering head tension is out of specifi-
cation (both handlebars should be within
specification), remove the upper bracket and
loosen or tighten the upper ring nut.
g. Reinstall the upper bracket and measure the
steering head tension again as described
above.
h. Repeat the above procedure until the steer-
ing head tension is within specification.
i. Grasp the bottom of the front fork legs and
gently rock the front fork.
Binding/looseness ! Adjust the steering
head.
EAS00149
CHECKING THE FRONT FORK
1. Stand the motorcycle on a level surface.
WARNING
Securely support the motorcycle so that
there is no danger of it falling over.
2. Check:
S inner tube 1
Damage/scratches ! Replace.
S oil seal 2
Oil leakage ! Replace.
3. Hold the motorcycle upright and apply the
front brake.
4. Check:
S front fork operation
Push down hard on the handlebar several
times and check if the front fork rebounds
smoothly.
Rough movement ! Repair.
Refer to "FRONT FORK" in chapter 4.
3-52
CHK
ADJ
Steering head tension
200 X 500 g