CONNECTING RODS AND PISTONS
b. Clean the connecting rod bolts and nuts.
c. Tighten the connecting rod nuts.
d. Put a mark 1 on the corner of the connecting
e. Tighten the nut further to reach the specified
When the nut is tightened more than the spe-
cified angle, do not loosen the nuts and then
retighten it.
Replace the bolt and nut with a new one and
perform the procedure again.
S Do not use a torque wrench to tighten the
S Tighten the nut until it is at the specified
NOTE:
When using a hexagonal nut, note that the
angle from one corner to another is 60_.
5-82
rod nut 2 and the connecting rod cap 3 .
angle (150_).
WARNING
CAUTION:
nut to the specified angle.
angles.
ENG