Yamaha FZ6-SS Service Manual page 304

CONNECTING RODS AND PISTONS
7. Tighten:
NOTE:
Install by carrying out the following procedures
in order to assemble in the most suitable condi-
tion.
a. Replace the connecting rod bolts with new
b. Clean the connecting rod bolts.
c. After installing the big end bearing, assemble
d. Tighten the connecting rod bolt while check-
NOTE:
To install the big end bearing, care should be
taken not to install it at an angle and the position
should not be out of alignment.
e. Loosen the connecting rod bolt, remove the
8. Install:
NOTE:
S While compressing the piston rings with one
S Make sure that the "Y" marks a on the con-
5-85
S connecting rod bolts.
24.5 Nm (2.5 mSkg, 17.7 ftSlb)
ones.
the connecting rod and connecting rod cap
once using a single unit of the connecting
rod.
ing that the sections shown a and b are
flush with each other by touching the surface.
S Side machined face a
S Thrusting faces (4 places at front and rear)
b
connecting rod and connecting rod cap and
install these parts to the crankshaft with the
big end bearing kept in the current condition.
S connecting rod assembly
(into the cylinder and onto the crankshaft pin)
hand, install the connecting rod assembly into
the cylinder with the other hand.
necting rods face towards the left side of the
crankshaft.
ENG