Table of Contents
Advertisement
Setting Value Accession Command
x Setting Value Accession
[Command] RMEM
([Parameter 1]) <Setting value selection (None, 1 - 2)>
None: Camera setting value accession
1: Filter factor accession (XCL-5005 only)
2: LUT value accession
[Process] Sends the data which can be set by Serial
communication and the camera information
(version) to the camera control application.
Another command is not accepted during
transmission of data.
[Data transmission] Transmits data continuously in each
category.
The transmitting data are shown in decimal number.
The followings are transmission format and the
transmission examples.
<Transmission format>
<Category>: <Data 1>, <Data 2>, <Data 3>, ...,
<CRLF>
<Transmission example>
CA: 1.00 <CRLF>
AF: 0, 0, 1023, 1023, ..., <CRLF>
SH: 0 <CRLF>
. .
.
OK <CRLF>
XCL-5005 Setting Values
Category
Content
name
CA
Camera
information
AF
AFE
SH
Shutter
TR
Trigger
DT
DTL
BR
Binarization
DG
Digital
GM
Gamma
FL
Filter
BN
Binning
PT
Partial
IO
IN/OUT
46
Command Specification
Data
Data
number
1
<Version>
4
<AFE gain-left>, <AFE gain-right>, <Clamp level-left>, <Clamp level-right>
3
<Shutter speed>, <Shutter speed adjusting value>, <Shutter speed fine-adjusting>
3
<Trigger mode>, <External trigger pulse polarity>, <Trigger overlap mode>
2
<DTL mode>, <Edge enhancement filter factor>
2
<Binarization mode>, <Binarization threshold value>
11
<Digital gain mode>, <Digital gain step>, <Digital pedestal mode>, <Digital
pedestal>, <Automatic clamp control setting>, <Automatic clamp control
convergence value>, <Automatic clamp control correlation factor>, <Digital
clamp mode-left>, <Digital clamp-left>, <Digital clamp mode-right>, <Digital
clamp-right>
6
<Gamma mode>, <Change point (256)>, <Change point (512)>, <Change point
(1024)>, <Change point (2048)>, <Change point (3072)>
1
<Filter mode>
1
<Binning mode>
6
<Partial scan mode>, <Partial scan read beginning position>, <Partial scan read
area>, <Partial scan offset value>, <Horizontal partial scan mode>, <Horizontal
partial scan column number>
7
<Trigger signal input selection>, <Grayscale output mode>, <Image output data
width>, <DC IN connector signal output setting>, <Serial communication speed
setting>, <Image output data tap>, <Flip-flop output setting>
Advertisement
Table of Contents
