Rear - Sony XCL-5005CR Technical Manual

Rear

d DC IN (DC power input) connector (12-pin)
d
d DC IN (DC power input) connector (12-pin)
You can connect a camera cable CCXC-12P05N etc. to
input the +12 V DC power supply. The pin configuration
of this connector is as follows. You can operate the
camera without using this connector when using a
PoCL-compatible camera module interface board.
For details on the pin arrangement, see the following
table.
Pin No. Signal
1 Ground
2 +12 V DC
3 Ground
4 NC
5 Ground
6 NC
* Signal output from the Tenth pin of 12 pins
connector
You can select one of the following signals according
to the setting.
Ground / DVAL output / Exposure pules output
The default setting in the factory is Ground.
e DIGITAL IF (Interface) connector (26-pin)
Camera Link Base Configuration: 1TAP/2TAP
You can connect a Camera Link cable to this connector
to control a camera module from a host device utilizing
the serial communication protocol while outputting a
video signal from the camera module. If you use a
camera module interface board with support for PoCL,
you can also supply power from this connecter. You can
input the external trigger signal via the 26-pin connector
and operate a camera module in the external trigger
mode. The output system allows you to change the
output tap, and you can select from 1TAP and 2TAP.
When setting the output tap, you need to set the camera
module interface board and change the file when you
change the camera settings. When images are not
8
Location and Function of Parts and Operation
e DIGITAL IF (Interface) connector (26-pin)
e
Pin No. Signal
7 NC
8 Ground
9 NC
*
10 Signal output
11 Triger pulse input
12 Ground
displayed correctly, refer to the user's manual and other
documentation for the camera module interface board,
and check the settings.
The following table shows the relation between the pin
numbers of the digital interface connector and the input/
output signals and the like.
Pin No. Signal
1 Power supply or
*
Ground
2 X0– output
(Signal)
3 X1– output
(Signal)
4 X2– output
(Signal)
5 XCLK– output
(Signal)
6 X3– output
(Signal)
7 Ser TC+ (Signal)
8 Ser TFG– (Signal)
9 TRIG– input
(Signal)
10 NC
11 NC
12 NC
13 INNER_SHIELD
(Ground)
* About the 1st pin and 26th pin of the 26-pin
connector
The connection differs depending on the type of
camera module interface board you use.
In the case of PoCL support:
Both the 1st pin and 26th pin are
POWER (power supply)
Pin No. Signal
14 INNER_SHIELD
(Ground)
15 X0+ output (Signal)
16 X1+ output (Signal)
17 X2+ output (Signal)
18 XCLK+ output
(Signal)
19 X3+ output (Signal)
20 Ser TC– (Signal)
21 Ser TFG+ (Signal)
22 TRIG+ input
(Signal)
23 NC
24 NC
25 NC
26 Power supply or
*
Ground