Table of Contents
Advertisement
Timing chart
Controller
Time out
Timing chart (loss of command)
Controller
Time out
Timing chart (loss of Acknowledge or completion message)
IP Related Setting
Command
Peripheral device
The following commands are provided for setting the
IP address and name of this unit.
No.
1
2
3
4
The network setting of the IP card is performed as
communication sequence in the following.
Peripheral device
1 Inquiry
The controller sends the inquiry packet to the
broadcast address (255.255.255.255), specified port
number (52380) of UDP. The IP card replies as the
inquiry reply packet.
2 Network setting
The controller sends the network setting packet to the
broadcast address (255.255.255.255), specified port
number (52380) of UDP. The receiving side sees the
MAC address unit in the packet, and returns
Acknowledge as the network setting reply if it is the
request for the receiving side.
Note
This unit takes up to a maximum period of 30 seconds to reflect the
setting after sending the network setting reply.
Wait for this period before sending the next network setting
command.
If this unit receives the network setting command from the
controller during this period, the network setting reply data with
NAK is returned.
Name
Description
Setting Protocol:
The controller inquires the
Inquiry
network setting for the camera.
Setting Protocol:
The camera replies according to
Inquiry reply
the inquiry from the controller.
Setting Protocol:
The controller sets the network
Network setting
setting of the camera.
Setting Protocol:
The camera replies according to
Network setting reply
the network setting of the
controller.
Command List
Advertisement
Table of Contents
