Setting Value Control Command; Setting Initialization Command; Save Setting Command; Read Setting Command - Sony XCL-5005CR Technical Manual

[Process] Selects an input route of the external trigger
signal.
x Flip-flop Output Setting (XCL-5005 only)
[Command] FLIP-FLOP
[Parameter 1] <Mode (0 - 1)>
0: OFF
1: ON
[Process] Sets the flip-flop of image output.
x Grayscale Output Setting (XCL-5005 only)
[Command] GRAYSCALE
[Parameter 1] <Mode (0 - 1)>
0: OFF
1: ON
[Process] Sets the grayscale mode.
x Color Bar Output Setting (XCL-5005CR only)
[Command] COLORBAR
[Parameter 1] <Mode (0 - 1)>
0: OFF
1: ON
[Process] Sets the color bar output mode.
x DC IN Connector Signal Output Setting
[Command] WEN-STRB
[Parameter 1] <Specification for 10th pin output (0 - 2)>
0: GND output
1: DVAL output
2: EXPOSURE output
[Process] Sets the 10th pin of DC IN connector signal
output specification.
x Image Output Data Width
[Command] IMG-WIZE
[Parameter 1] <Image output data width (0 - 3)>
0: 12 bit output
1: 10 bit output
2: 8 bit output
3: RGB 24 bit output (XCL-5005CR only)
[Process] Sets the image output data width.
x Image Output Data Tap
[Command] IMG-TAP
[Parameter 1] <Image output data tap (0 - 1)>
0: 80 MHz 1TAP output
1: 40 MHz 2TAP output
[Process] Sets the image output data tap.
x Serial Transmission Speed Setting
[Command] BRATE
[Parameter 1] <Baud rate (0 - 3)>
0: 9600 bps
1: 19200 bps
2: 38400 bps
3: 57600 bps
[Process] Sets the serial transmission speed.

Setting Value Control Command

The setting value control command controls camera
setting data saved in the Flash ROM inside the camera.
The following list shows the contents.
Command Explanation
Initialization Initializes the data corresponding to the
of setting camera control command to the factory
value setting value.
Save setting Writes the data corresponding to the camera
control command in the Flash ROM.
Read setting Reads the data corresponding to the camera
control command in the Flash ROM.
Setting value Sends the necessary data to the camera
accession control application.

Setting Initialization Command

Note
Some data are not initialized by executing the following
commands. For details, refer to "Parameter List" on
page 51.
x Initialization of Setting
[Command] INIT
[Process] Initializes the data corresponding to the
camera control command to the factory setting value.

Save Setting Command

x Save Setting
[Command] SAVE
[Process] Writes the data corresponding to the camera
control command in the Flash ROM.
Another command is not accepted during execution
of the process. After completion of execution, the
following message is displayed.
"OK": Normal completion
Note
If the completion is not normal, the saved data may be
damaged.

Read Setting Command

x Read Setting
[Command] LOAD
[Process] Reads the data corresponding to the camera
control command in the Flash ROM.
45
Command Specification