Advertisement
Timing chart
Controller
Time out
Timing chart (loss of command)
Controller
Time out
Timing chart (loss of Acknowledge or completion message)
IP Related Setting
Command
Peripheral device
The following commands are provided for setting the
IP address and name of this unit.
No.
1
2
3
4
The network setting of the IP card is performed as
communication sequence in the following.
Peripheral device
1 Inquiry
The controller sends the inquiry packet to the
broadcast address (255.255.255.255), specified port
number (52380) of UDP. The IP card replies as the
inquiry reply packet.
2 Network setting
The controller sends the network setting packet to the
broadcast address (255.255.255.255), specified port
number (52380) of UDP. The receiving side sees the
MAC address unit in the packet, and returns
Acknowledge as the network setting reply if it is the
request for the receiving side.
Note
This camera requires up to 30 sec. to reflect the settings, after
sending the network setting responses. Make sure to send the next
network setting command after 30 sec. passes. If this camera
receives network command during this 30 sec from controller, this
camera returns the setting response data with NAK set.
Name
Description
Setting Protocol:
The controller inquires the
Inquiry
network setting for the camera.
Setting Protocol:
The camera replies according to
Inquiry reply
the inquiry from the controller.
Setting Protocol:
The controller sets the network
Network setting
setting of the camera.
Setting Protocol:
The camera replies according to
Network setting reply
the network setting of the
controller.
Advertisement
