Table of Contents
Advertisement
System Components
Video Camera Module
Camera cable
XCL-5005CR/5005
CCXC-12P02N (2 m, 6.6 ft)
CCXC-12P05N (5 m, 16.4 ft)
CCXC-12P10N (10 m, 32.8 ft)
CCXC-12P25N (25 m, 82 ft)
Camera module interface
board
Camera Link cable
(Sony Camera-compatible)
C-mount lens
High-resolution lens
Install the board in a PCI bus slot in devices such as a computer. Select a commercially available interface
board compatible with the Camera Link feature. You can use either a board that supports PoCL, or one
that does not.
In the board corresponding to PCI 32 bit, the frame rate may become low according to lack of processing
capacity. When you want to make this product output 15 frames per second, use a board corresponding
to more than PCI 64 bit (PCI-X).
When you use XCL-5005CR with RGB data output, the frame rate may become low because of insufficient
processing capacity even if you use a PCI 64 bit compatible board. If you want to output 15 frames of
images every second, use a PCI Express board. Performance may also be dependent on the host device
(e.g., Computer), so consult the dealer if images are not displayed properly.
This cable connects to the digital interface connector on the rear panel of the camera module. Image/
control signals are transmitted via this cable.
If there is support for PoCL, power is also supplied at the same time. If you use a camera module interface
board with support for PoCL, be sure to use a camera link cable with support for PoCL. You can use a
single cable up to 7 meters long in the case of 1TAP output, and extend the cable length even further in
the case of 2TAP output. Select a proper cable as the maximum usable length of a cable differs due to the
attribute of each cable.
Spotted noise may appear in a specific brightness in the window according to the attribute of the cable. If
this noise is an obstacle, shorten the cable.
Camera adaptor
Tripod adaptor
DC-700/700CE
VCT-ST70I (Insulated type)
System Components
5
Advertisement
Table of Contents
