Programmable Filter/Heating Cycles (Economy Mode Only) - Sundance Spas 880 Series Owner's Manual

12.2

Programmable Filter/Heating Cycles (Economy Mode Only)

Your hot tub comes with four 30-minute filter cycles which activate the
filter/circulation pump while in economy mode. These cycles are factory
programmed to start at 6:00 AM, 12:00 (noon), 6:00 PM, and 12:00
(midnight). The control system allows you to easily adjust two separate
aspects of each cycle:
• The time of day at which it begins;
• The duration of the cycle.
Note: When "Economy" mode is selected (Section 11.3), the heater
activates only during a programmed filter cycle period. When a Summer
Logic condition is active, the filter/circulation pump will turn on for all
programmed filter cycles.
Summer Logic: In warm weather, the water temperature in the
hot tub may exceed the set temperature. This condition may occur
due to heat transference from the filter/circulation pump and jets
pumps. If the water temperature is higher than 95°F (35°C) and
rises two degrees above the set temperature, a "Summer Logic"
condition occurs that deactivates the filter/circulation pump and
CLEARRAY. This safety feature cannot be altered! The filter/
circulation pump and CLEARRAY will remain off until the water
temperature cools to the set temperature. A mandatory cycle runs
from 9am-11am only when the spa is in summer logic.
Note: Pressing the select button at this time will reactivate the
circulation pump and waterfall feature for 1 hour. To help prevent
a "Summer Logic" condition, it may be necessary to reduce filter/
circulation pump cycle run times in warm weather.
Press the (MODE)
adjustments, first press the (CYCLE)
programming mode. The LCD screen will display the following in the
upper right corner:
This means the system is ready to accept you changes to the start time
for cycle number one. Simultaneously, the large four-digit display in the
center of the screen displays the currently programmed start time for that
cycle. At this point, you have four options. You may:
1. Press (UP)
increments of 30 minutes.
button to select "Economy" mode. To make
*
or (DOWN)
880 EXPORT SERIES
button to enter the filter cycle
*Note: Number will vary
according to which filter
cycle is being programmed.
button to adjust the start time in
Page 31