Table of Contents
Advertisement
3. The LED indicators on both the Ethernet port and the ex
ternal Ethernet hub or switch should be ON.
Note:
If the Ethernet cable is not long enough to reach the
external hub/switch, purchase a longer straight-through
10Base-T Ethernet cable.
2.2.3 Installing USB ADSL Modem firmware
The following document describes how to install and configure the
router with your USB modem. Please follow the instructions
closely, step-by-step:
Preparation
Do not connect the USB modem to the router yet.
1. Connect the router to the PSU(Power supply unit) and an
Ethernet cable between a PC and any one of the router 's four
Ethernet sockets.
2. If the PC is set to obtain IP address automatically (recom-
mended), reboot the PC and ensure that it has obtained an IP
address from the router (you can use Windows winipcfg.exe
or ipconfig.exe to check). You can use windows ping.exe to
check that your PC can see the router successfully (ping
192.168.1.1).
3. Insert the supplied DrayTek CD into your PC, and install the
Router Tools.
2-5
Advertisement
Table of Contents
