Table of Contents
Advertisement
VPN
Must: Species L2TP over IPSec.
If IPSec Tunnel or L2TP with IPSec Policy set to Nice to
Have or Must, select security methods as described in
followings. Please refers to section 4.2 to set up IKE pre-
shared key and IPSec security method.
PPP Authentication: Refer to Dial-Out Settings.
TCP/IP Network Settings
The following settings are required for proper LAN-to-LAN
operation.
My WAN IP: (can use default) In most cases you may
accept the default value 0.0.0.0 in this field. The router will
then get a WAN IP address from the remote router during
the IPCP negotiation phase. If the WAN IP address is fixed
by remote, specify the fixed IP address here.
Remote Gateway IP: (can use default) Specify the IP ad-
dress of the remote router.
In most cases you may accept the default value 0.0.0.0 in
this field. The router will then get a WAN IP address from
the remote router during the IPCP negotiation phase. If the
WAN IP address is fixed by remote, specify the fixed IP
address here.
Remote Network IP: (must specify) Specify the network
identification of the remote network. For example,
192.168.1.0 is a network identification of a class-C subnet
with netmask 255.255.255.0 (/24).
VPN-18
Advertisement
Table of Contents
