Error Codes - Baumatic BHI625 Instruction Manual

o The residual heat indicator has not come on after I have
switched a cooking zone off.
* The cooking zone has only been turned on for a short period of
time; therefore it did not go above 60°C.
* IMPORTANT: If the cooking zone does appear to be hotter than
60°C and the residual heat indicator has not come on, you
should call the Baumatic Customer Care Department.
o A humming sound is heard when a cooking zone is
selected.
* This is normal; the sound will disappear when the zone heats up.
o The cooking zones have become discoloured.
* This maybe caused by burnt on remnants of food. This will not
affect the working of the appliance. However you should make
sure that the cleaning instructions are being followed regularly.
o Only two of the zones on my hob are working
* You should recheck that the terminal screws are all fully
tightened between the links.

Error codes

The following error codes may appear in the timer display if there is a
problem with the operation of the hob.
Error Likely cause
code
F3-F8 Thermo component
failure.
F9-FE Temperature sensor
of IGBT failure.
E1-E2 Abnormal supply
voltage.
E3-E4 Abnormal
temperature.
E5-E6 Bad cooking zone
heat radiation.
IMPORTANT: If any other error codes appear on the cooking
zone display, you should turn the appliance off at the mains
and contact the Customer Care Helpline. DO NOT continue to
use the appliance.
Possible solution
Turn the power off and restart when
the temperature returns to normal.
Turn the power off and restart when
the temperature returns to normal.
Check the power supply to the
appliance is correct.
Check the pot being used is suitable.
Turn the power off and restart when
the cooking zone cools down.
Turn the power off and restart when
the cooking zone cools down.
30