My Appliance Isn't Working Correctly; Error Codes - Baumatic PI645 Instruction Manual

My appliance isn't working correctly

Error codes

Error code
F0/F1/F2
F3 – F8
E1/E2
E3/E4
E5/E6
* IMPORTANT: If these error codes appear frequently, then check
that the installation of the hob has been completed correctly. In
particular, pay attention to the ventilation requirements specified in
this manual.
o The cooking zones are not functioning or will not switch
on.
* It has been more than two minutes since the appliance was
switched on. You should switch the appliance on again, using the
ON/OFF button.
* You have not placed an appropriate pan on the zone that you are
trying to get to heat.
* The safety lock has been switched on (see the "Switching on the
safety lock" section for information on how to turn off the safety
lock).
* Several touch control buttons have been pressed at once. You
should only touch one touch control button at a time.
* The safety cut out has been triggered. Press the ON/OFF button
(9) to reset the appliance.
* Check that the mains electrical supply to the appliance is correct
and working. Check the mains fuse.
Possible causes
Fan failure
Temperature sensor
failure
Abnormal supply
voltage
High zone
temperature
High hob temperature
29
Solution
Contact the Baumatic
Service Department
Contact the Baumatic
Service Department
Check that the power
supply the hob is
connected to is
appropriate. (See the
diagram on page 27).
Allow the hob to cool
and then restart it. *
Allow the hob to cool
and then restart it. *