Troubleshooting Guide - Evo 423T Owner's Manual

1. Probable reason for the computer not working: The wire from computer to bottom control board is
not correctly connected. Check the each wire from computer to control board, make sure they are
connected well. If the wire is destroyed, change it. If the above cannot fix the problem call our
service centre on 1300 796 636.
2. "E01": Message failure. Probable reason: The wires from computer and bottom control board are
not connected well, please check each wire.
3. "E02": You may not have enough voltage going to the machine. Turn the machine off and on again
at the switch at the rear of the treadmill. If this does not fix the problem you may have damaged
the lower circuit board. Contact our service centre on 1300 796 636
4. "E03": No sensor signal. Sensor wire is faulty, replace the sensor wire. Magnetic sensor wire is not
working change the magnetic wire or reset the magnet.
5. "E04": Incline motor wrong, check if the VR of the incline motor connects well or replug it. The mark
of the DC motor and control board should be matched connected. Sometimes you also need to
check the wires of the motor and restart the whole treadmill again.
6. "E05": Current overload protecting. Power surge or the motor is seized which will cause excessive
current. At this time the treadmill will start its self-protecting system. Adjust the machine and
restart; Check if the motor is noisy or if the motor / bottom control board is burnt out, if burnt out,
change the motor and/or bottom control.
7. If the motor does not work after pressing the START button, the probable reason: the motor wire

TROUBLESHOOTING GUIDE

17
www.evofitness.net.au