Table of Contents
Advertisement
34
Legend
Installation Manual
7. Securely fasten the arm to the mounting
surface with the appropriate fasteners.
Again, ensure that it is level.
8. If needed, seal all mounting holes so that no
moisture can leak into the mounting surface.
9. Push inside the arm or pull taut any
looped cables that are extending out of
the access area.
10. Reattach the cover.
11. Before you attach the housing to the arm,
attach the housing safety cable to the arm
safety chain.
Note:
The safety cable for rugged housings is metal
and for plastic housings is a beaded cord.
a. Cut the quick tie on the safety chain.
b. Hold the housing near the arm's collar.
c. Slide the ball of the safety cable into the
clip of the safety chain.
d. Ensure that the safety chain and cable
bears the housing's weight.
e. Lower the housing until the safety chain
and cable are taut.
12. Return to
Installing the housing
on page 8 to finish installing the dome.
Figure 32. Fastening the arm to the mounting surface
See Table 1,
requirements of dome con-
figurations
Figure 33. Reattaching the access cover
Figure 34. Attaching the housing safety cable to the arm safety chain
Minimum load
on page 4.
Quick tie
Safety chain
Clip
Safety cable
Advertisement
Table of Contents
