GE Legend Installation Manual page 13

Figure 6. Installing the flush-mount housing
Safety cable
3/4 in. conduit knockouts (2)
Nipple
(snipped off to access
the safety cable clip,
which is inside the housing)
Cables fed
through mount
and housing
Clip for safety cable
(inside housing)
Building superstructure
Housing tabs (3)
(screwed open and down
against the mount or ceiling)
Ceiling ring
Angle brackets (2)
Ceiling
Flush-mount cabling
Cables are fed in through:
• the cable entry hole in the side (or top) of
the housing;
• the power cable runs over the top of the
upper bracket and down beside the
power connector; and
• the remaining cables run down through
the center hole in the upper bracket.
Upper bracket
Power cable
9