Table of Contents
Advertisement
Installing the housing
With the pipe or mount now installed, install the housing.
Avoid getting rain or moisture in the housing so that the electronic components on the PCBs are not damaged.
CAUTION
CAUTION
To install the housing to a pipe or mount, see Figure 7 on page 12 and do the following:
1. If installing the housing onto a pipe:
a. Spray soapy water on the pipe.
b. For outdoor applications, slide the water-sealing rubber boot onto the pipe.
c. Apply Teflon tape to the pipe threads.
2. Hold the housing up near the pipe or mount. If you installed the GEA-102 wall-mount arm, make sure
that the safety chain is securely attached. See
DO NOT run any cables next to the heaters. Doing so could damage the dome or cause an electrical fire.
WARNING
3. Feed the facility cables through the dust seal in the top of the housing. Allow enough cable length to
make connections. Figure 7 on page 12 shows how the cables run through the housing.
For safety, the mounting surface, hardware, and procedure used for securing the dome must support the
CAUTION
CAUTION
weight of the dome, mount (if used), cables, and any structural or environmental vibration according to
local codes. See Table 1,
4. Attach the housing to the pipe or mount.
•
For pipe installations, thread the housing onto the pipe. If necessary, first turn the housing
counterclockwise to compensate for the cable twisting.
•
For wall mount installations, use the fasteners that were provided with the mount.
GEA-102 wall-mount arm
Minimum load requirements of dome configurations
on page 32 for details.
on page 4.
11
Advertisement
Table of Contents
