Table of Contents
Advertisement
28
Legend
Installation Manual
Common installation issues
Following are the solutions to the most common issues users have with installation. Solutions are given in the order
of most to least likely cause.
Note:
For programming and operating issues, refer to the
controller keypad.
Is the dome resetting during power-up, not powering up at all, or powering up but not operating as
expected?
Verify that you are supplying sufficient power for your model of dome. See
page 6.
Are the diagnostic LEDs not illuminating?
•
First, look at and feel the camera assembly to make sure that it is fully engaged with the upper bracket.
Remember that the alignment tabs and slots are color coded. Is orange engaged with orange and white
with white? Are the pawls seated on their corresponding landings? Is the interconnect card fully seated
into its socket? If not, remove and reinstall the camera assembly. See
on page 20.
•
If that doesn't work, then check the power cable and verify that it is properly connected. See
the housing board
Is video not appearing on the monitor screen?
•
First, look at the LEDs that are visible below the dome and verify that the unit is powered and that the
programming is running. See
powered or the programming is not running properly, remove and reinstall the camera assembly. See
Installing the camera assembly
•
If the video still does not appear, then check the video cable and verify that it is properly connected.
For UTP video, ensure that the + and - ends of the cable are correctly connected to maintain the polar
sensitivity of the UTP video cable. See
Do you have video but no PTZ control?
•
First, verify the address of the dome. You can do this easily by pressing and holding the view key on
the KTD-405 keypad. The dome's information will be displayed on the monitor screen. If necessary,
correct the address
and/or protocol using the procedure in
•
If you still don't have control of the video, verify that the data cable is properly connected. See
the housing board
•
Finally, try resetting (cycling) the power to the dome by turning the power off then on.
on page 15.
Camera assembly power indication
on page 20.
Wiring the housing board
Addressing the camera site and setting the protocol
on page 15.
Legend User Manual
(1052027) and the user manual for your
on page 27. If the dome is not
on page 15.
Power requirements
Installing the camera assembly
on page 18.
on
Wiring
Wiring
Advertisement
Table of Contents
