Maintenance; Resetting The Dome; Rebooting The Dome; Cleaning The Bubble - GE Legend Installation Manual

Maintenance

Resetting the dome

You can reset the dome whether or not you have valid communication between the keypad and the dome.
To reset the dome, cycle the power to the dome by turning the power off then on.

Rebooting the dome

If you have valid communication between the keypad and the dome, then you can reboot the dome.
If the dome needs to be rebooted, do the following from the KTD-405 keypad:
1. At the normal display, press and hold the set (
programming code display appears on the keypad's LCD.
2. At the ENTER PROGRAMMING CODE: display, enter the reset access code by pressing the 1, 4, 7,
6, and seq keys.
3. At the RESET TO DEFAULTS? display, press iris + for yes.
4. At the reset which display, press 3 to select CAMERA.
5. At the RESET CAMERA #? ARE YOU SURE? display, press iris + to select yes.
The camera will reboot in 3 to 5 seconds. You will see the RESETTING CAMERA # display on the
keypad LCD and the splash screen and color bars on the monitor screen as the camera reinitializes itself.

Cleaning the bubble

Use the following procedures for cleaning the bubble. Be aware that the interior of the bubble requires extra
care in cleaning. Use only the procedures provided below.
For warranty protection, comply with this section's bubble handling procedures.
CAUTION
CAUTION
To prevent damage, do not touch the bubble with your bare hands, do not place the bubble face down on
any surface, and protect the bubble from dust. Oil and acid from your hands can etch some bubble
surfaces and are difficult to remove. Use a scratch-resistant cloth or gloves when handling the bubble.
Cleaning the exterior of the bubble
To clean the exterior of the bubble:
Use any nonabrasive cleaning cloth and a cleaning agent that is safe for use on polycarbonate or acrylic plastic.
Liquid or spray cleaner/wax suitable for fine furniture is acceptable.
Do not use this procedure for cleaning the interior of the bubble. See
) key on the keypad until you hear a beep and the
Cleaning the interior of the
29
bubble.