Turning On The Passcodes - GE Legend Installation Manual

24 Legend
Installation Manual

Turning on the passcodes

The last task of installing the dome is turning on the passcodes, if desired, before going to the user manual to
program the dome. The passcodes control who has access to the features of your dome. Only the installer
through the installer passcode has permission to turn on, turn off, or change the passcodes.
The dome ships with no default passcodes. When you enter the programming interface for the first time during
installation and go to Setup | Passcode, the passcode fields are blank. Blank passcode fields mean the
passcodes are turned off (disabled). You can choose to enter passcodes into the blanks. This turns passcodes on
(enables them) and a passcode will be required to enter the programming interface the next time you access it.
CAUTION
CAUTION
If no passcodes are programmed, all users are given installer access and are not required to log on. If only the
Admin and Operator passcodes are programmed, then anyone can still access the entire programming interface
as an installer, since the Installer passcode was not programmed.
You can turn on one installer passcode, one admin passcode, and one operator passcode. They have the
following permissions:
Installer: The installer passcode allows access to all dome features.
Admin: The admin passcode allows access to all dome features, except passcodes and firmware
upgrades.
Operator: The operator passcode allows no access until it is granted access to specific features on an
area-by-area basis.
To access the programming interface and turn on passcodes, do the following:
1. At the normal display, press and hold the set
( ) key on the keypad until you hear a
beep and the programming code display
appears on the keypad's LCD.
2. At the enter programming code display, enter
the programming access code by pressing the
9, 5, 1, and seq keys.
This code is the same for all GE keypads.
If using passcodes, record them in a secure place. If you forget the passcodes for a dome, you will need to
send the dome back to the factory so that it can be reset by the factory with no passcodes.
Figure 17. Normal display (visible before programming interface accessed)
CAMERA 1
MONITOR 1
Figure 18. Enter programming code display
ENTER PROGRAMMING
CODE: _