Table of Contents
Advertisement
3. At the equipment selection display, press 3 to
select CAMERA on keypads of version
1.2.09 or later (Figure 19) or CAMERA/
RCVR on keypads of version 1.1.06 or
earlier (Figure 20).
If you have an older keypad (version
1.1.06 or earlier), you will have a second
equipment selection display, at which
you need to press 1 for CYBERDOME.
Figure 20. Equipment selection display for keypad versions 1.1.06 or earlier
1=SWITCHER/MPLX 2=ALARMS
3=CAMERA/RCVR
4. At the enter site number display, enter the
number for the camera site you are
programming. This is a 3-digit number
(e.g., 007, 021, 243).
You can enter the three digits (e.g., 007),
or enter one (e.g., 7) or two (e.g., 21)
digits and press the set (
5. Continue entering commands with the
joystick.
6. Since passcodes are turned off by default,
upon initial installation you can directly
access the programming interface without a
passcode.
Note:
For complete instructions for navigating
and programming the programming
interface, refer to the Legend User Manual
(1052027).
EXIT
!
) key.
Figure 19. Equipment selection display for keypad versions 1.2.09 or later
1=SWITCHER/MPLX 2=ALARMS
3=CAMERA
Figure 21. Second equipment selection display for older keypads
1=CYBERDOME 2=PTZ
3=AUXILIARY
Figure 22. Enter site number display
ENTER CAMERA SITE
NUMBER _ _ _
Figure 23. See Monitor For Menus display
SEE MONITOR FOR MENUS
HOLD SEQ (3 SEC) TO EXIT
Figure 24. First screen of programming interface when passcodes are
turned off
EXIT
!
BACK
"
BACK
"
25
Advertisement
Table of Contents
