Sub-Menu: Settings - TIPTEL .com 410 Installation Manual

•
Call deflection subscriber
•
Answering machine ready (only with tiptel VCM-Module installed)
•
Announcement of answering machine (only with tiptel VCM-Module in-
stalled)
•
With day/night switching enabled you can define up to 6 different profiles. This is
done via the corresponding configuration page with the above-mentioned settings
(e.g. subscriber settings).
On each of these configuration pages you will then find a new bar "day/night switch-
ing" at the top. By clicking the corresponding profile the display of the current con-
figuration page with the corresponding settings will change accordingly. All settings
of this page marked in yellow are dependent from the chose profile. Change of these
settings will only apply to the currently chose profile.
Note: You may want to check the yellow marked settings in all profiles in case
switching between the profiles unwanted changes in subscriber con-
figuration appears.

Sub-menu: Settings

Profile name
There are 6 profiles available in the configuration. You can enter a different name for
each profile (e.g. day, night, break etc.).
Activating individual profiles (on/off)
Here you can switch individual profiles on or off. The activated profiles are available
for selection on the corresponding configuration pages. Switching between profiles
either takes place using the system buttons on the system telephone, through the
web interface or the time control.
Activated profile
Here you can activate the desired profile.
Time control
Here you can activate the time-controlled switching of profiles.
Authorisation for web configuration
Here you can set the authorisation to select a profile over the web. For this select the
desired subscriber. After dialling using the subscriber access data, the subscriber is
available on the relevant menu.
Configuration menu: Settings
47