General; Settings; Automatic Exchange Connection; Pick-Up - TIPTEL 3022 office User Manual

General

Settings

Automatic exchange connection

After picking up the receiver, the telephone system will automatically perform a
standard exchange connection, i.e. the telephone system imperceptibly dials "0". If a
CO line is available, you will immediately hear the external dialling tone. If all external
lines assigned to the subscriber are busy, the internal busy tone is heard.
Automatic exchange connection is only performed for the first connection setup. For
setting up further connections – e.g. for an inquiry call – the internal dialling tone is
heard first. If you wish to place another external call, the line prefix must be dialled.
If the feature automatic exchange connection has been activated, you can dial

" " for an internal line or wait for 10 seconds after picking up the receiver until
you hear the internal dialling tone. Then the desired extension number can be
dialled.
After 10 seconds, the telephone system automatically switches to the internal
dialling tone.
Automatic exchange connection is also performed if no exchange authorisation is
available. This is necessary in order to ensure that emergency phone numbers can
be called. As soon as an additional digit is dialled, which does not belong to an
emergency number, the connection will be terminated.
Requirements:

Pick-Up

This menu serves to set whether an incoming call may be picked up by another
subscriber or not. Select setting "answering machine", if you wish to operate an
answering machine at this extension. It is then possible to pick up the call even after
it has been answered by the answering machine.
Configuration via PC
The feature "automatic exchange connection" must be
enabled. Additionally the required exchange authorisation
must be available.
20