Quick Start - TIPTEL .com 410 Installation Manual

Quick start

Configuration can be carried out via LAN, via the internet, or via ISDN dial-up.
Note: In case the IP address was changed, please use the current IP address
instead of the one mentioned below.
There are several ways how the configuration interface can be accessed:
•
Using the installation assistant on the attached CD for your first configuration
steps. This assistant will guide you step by step through all necessary steps
- starting with the terminal connections and ending with the system's con-
figuration.
This assistant runs in Windows® VISTA, XP, 2000, or ME. You may also
reach the configuration section of the assistant under
"http://192.168.34.100/wizard/".
•
You are familiar with the system, disregard the assistant, and carry out the
configuration of the telephone system directly via http://192.168.34.100/.
•
In case you wish to configure the system via the internet please configure
the internet access device (router) of your customer in such a way that you
can access the customer's LAN from the outside. You may want to use a
DynDNS-Service, in case the customer does not have a fix WAN-IP-address.
And do not forget to forward port 80 (configuration port of the telephone
system) to IP address 192.168.34.100. Set the system's standard gateway to
the router's IP address.
•
The telephone system has only been installed at the customer's site but the
configuration is faulty or even not existent. Ask the end-user to enter the key
sequence
point-to-point ISDN access (unlock remote configuration/service). During
the next 15 minutes you may log in to the customer's telephone system via
an ISDN adapter. You can use any of the customer's phone numbers. In this
case user name and password are the factory default settings "ad-
min/Admin".
•
If you are at the customer's site, with tiptel.com 411 and tiptel.com 811 you
may also dial-up to the system via the internal S0-Bus. In this case please
use the internal telephone number 99 for dial-up via an ISDN adapter.
•
After entering the IP address in your browser (in case of ISDN dial-up please
check the connection details for the server IP address) you will be asked for
user name and password. The factory default setting is "admin/admin".
•
You will now see the web configuration interface. If you do not see the con-
figuration interface please read the following chapters or the Quick Start
Guide first.
Quick start
at any telephone or
15
at a