TIPTEL .com 410 Installation Manual page 20

If e.g. you want to split the internal S0-bus of tiptel.com 411 or 811 into two
directions starting at the telephone system you will have to remove the internal
termination resistors. Remove both jumpers of JP506 (shown in the picture on
the left).
6. For analogue terminal units such as telephones, fax machines, or answering
machines there are two connectors available.
a) Screwing terminals for 4 or 8 subsribers:
Each wire pair of your installtion cable is to be connected to on end of the
screwing terminal pairs 1 through 8. Only use twisted pair cable, type J-
Y/ST/Y.
You may now refit the housing cover. Make sure that the rear fittings of the cover
are matching the rear slots of the housing bottom. Now push the cover down at
the terminal area until it snaps in.
b) Western-jacks for the first 4 extensions:
Use only one single device with each connector in the centre of the terminal
First start-up
20